How a dust laptop is cleaned

The problem, which consists in overheating the laptop or laptop closes during the games is the most common of all the other problems with laptops. One of the main reasons, which leads to the overheating of the laptop – dust in the cooling system. In this article I will describe in detail how a dust laptop is cleaned.

Modern laptops are a fairly strong hardware device, which in the operating process tends to generate heat, especially in cases where the laptop carries out complex activities (the best example – computer games). So, if your laptop becomes hot in certain places or closes by itself at the most inappropriate moment and fans of the laptop «scream» more than usual, the problem as much as possible, overheating the laptop.

If the laptop warranty has expired, you can easily travel the steps in this article to clean the dust laptop. If the warranty is still valid, you have to be very careful, because many laptop producers provide for the loss of the guarantee if the laptop has been canceled and we will do it.

The first way to clean the laptop – for beginners

This method of cleaning the dust laptop is useful for those who are not good in computers and components of computers. Even if in the past you have not disassembled computers and in particular laptops, follow the following steps and you will be successful.

You can also clean the fan with compressed air. Use short «jet», so don't rotate the fan too much. In addition, everything must be cleaned of the pallets for fans. Do not press the fan. Another important point: the compressed air spray should be kept in a vertical position, without turning it, otherwise it can reach the liquid air, which can cause damage to the electronic components.

Some models have several fans and radiators. In this case the passages described above are repeated.

Step 3 – Cleaning assembly and additional laptop

After finishing the previous step, it is possible to clean the dust and the other parts of the laptop, using the same spray by compressed air.

Make sure you have not touched the connectors or other components in the laptop, then put the lid in place and screw the screws, bringing the laptop to the initial state. In cases where the screws are hidden behind the rubber feet, they must be blocked. If this is applied on your laptop – I necessarily do it, in cases where the vent holes are on the bottom of the laptop, the presence of the «feet» is mandatory – create a space between the laptop and the surface on which the laptop is positioned, to allow access to the air to the cooling system.

Now you can put the battery in place, connect the charger and check the operation of the laptop. Most likely, you will notice that the laptop does not produce so much noise and does not heat up so strong.